FEDEVEL
Platform forum

Sniper2 , 05-25-2025, 08:25 PM

So there are a lot of pull ups and dows that i need to change in some schematic sheets based on variant.
I know how to drag select them and make them DNP. but how do i change the actual part number? like from 100k to 1k ? if i know the part ID?
Thing is i know how to do it individually but man that will take ages to make them all what they should be .
Is there a way yo change them en mass?

QDrives , 05-25-2025, 10:11 PM

With variants there is the DNP and alternative parts. It s the last bit that you want.
Doing it en mass? Not to my knowledge. I do not think you can use a blanket for this.

Sniper2 , 05-26-2025, 05:32 AM

Ok thx