Question about Stripline and Impedance
Bermell , 08-31-2022, 05:09 AM
Hello,
I need to use controlled impedance so I have to calculate the width for single tracks and width and gap, for differential pairs .
I use the PCB Saturn software. For the microstrip case, I think it is easy to get it.
My question is about stripline:
In the software, i can set the geometry, but i can't set the funcionality of the reference planes. I mean, there is a reference plane above and below, so does the type of reference plane not matter ? What happens when one reference plane is GND and the other one is a power plane?
I don't know if this question has been asked before.
Thank you very much in advance
robertferanec , 09-01-2022, 10:47 AM
Use our interactive
Discord forum to reply or ask new questions.