USE DISCOUNT CODEEXPERT30TO SAVE $30 USD
Coplanar Waveguide Grounded In Orcad PCB
maxg31 , 10-29-2018, 03:55 AM
Hello everyones,
I'm trying to make a transmission line in orcad PCB lite. I decided to use a dynamic shape to trace the CPW Grounded but even if I assigned my net there is still a gap between the components pin and the trace ...
This is ithe first time I use Orcad PCB to make RF transmission line, can anyone help me please ?
Thank you !
I'm trying to make a transmission line in orcad PCB lite. I decided to use a dynamic shape to trace the CPW Grounded but even if I assigned my net there is still a gap between the components pin and the trace ...
This is ithe first time I use Orcad PCB to make RF transmission line, can anyone help me please ?
Thank you !
robertferanec , 10-31-2018, 07:48 AM
You need to set thermal relief. There are more ways. If you would like to set it up for the whole design, go to Setup -> Design Parameters ... -> Shapes -> Dynamic shape -> Edit global dynamic shape parameters. Then click on Thermal Relief TAB and set Smd pins: Full contact
maxg31 , 11-05-2018, 12:34 AM
Great, thank you very much Robert !
Use our interactive Discord forum to reply or ask new questions.