FEDEVEL
Platform forum

Juan , 01-30-2018, 02:31 AM

Hello

My question is how i can import the logo company .ai in my design PCB, i have proved to convert the .ai in dxf and import to Allegro16.6, but the logo is bad and the logo not is shown complete

Thanks in advance

robertferanec , 01-31-2018, 09:45 AM

When I need to import logo, I create a new Mechanical symbol and import it as an image. Maybe that could help you?

Juan , 01-31-2018, 10:45 PM

Hi Robert:

Thanks in advance, yes i have probed this, but i don't have the option to import-logo in my Allegro version,it is depend of the license ? Or i need configure anything?

Thanks

robertferanec , 02-01-2018, 07:57 AM

Import LOGO option is only available when you are creating mechanical component: File -> New -> Mechanical symbol. The option is not available when you are editing board (brd file)

Juan , 02-02-2018, 05:31 PM

Many Thanks Robert, At the end i have could import in .dxf and to save like mechanical symbol. Best Regards

, 07-22-2019, 07:09 AM

Dear sir , even though i' am trying to import logo in mech symbol editor but i haven't found logo option please find the attached ref image

robertferanec , 07-24-2019, 07:21 AM

Guest, hmm, do you use Allegro 17.2? Maybe you have a different version?

, 08-01-2019, 04:50 AM

yaa its there sir ,thanks .

, 08-01-2019, 04:55 AM

sir i have a question ,when i am generating schematic pdf the pages aren't in a order .like example if we have 8 pages schematic first pages goes to 7 in pdf ,viceversa

robertferanec , 08-02-2019, 07:26 AM

Did you set page numbers in your schematic sheets?

, 08-05-2019, 06:11 AM

i haven't check the schematic page numbers.it is ok now