iMX Solo in OpenRex board
diegopm , 06-05-2017, 02:10 AM
Hello
I have a question about OpenRex board,
Is it possible to mount a iMX Solo, there are some differences against iMXQ, like power rails and the DDR3 bus, in case of Solo is 32 bit. I read in the schematic a note that says, “When iMX6 Solo Processor will be used (32-bit data bus), do not fit U4 and U5.†So I think the design is optimized to be able to mount a iMXSolo. But it has been tested?
Best Regards
Diego.
robertferanec , 06-05-2017, 06:17 AM
Diego, yes, it is tested and you can buy also OpenRex SOLO version from VOIPAC.
Use our interactive
Discord forum to reply or ask new questions.