Platform forum

Vias for Connectors

nikhil2402 , 06-11-2016, 04:50 AM

I am using Samtec QSH type of connectors for my project. This connector is placed on the top layer along with other components. Many signals that go to this connector are present in middle layer and in order to bring them to top layer I am using vias. These vias are affecting the placement of other components on top layer. I have already adjusted the components such that there are no more errors.

However, I was wondering if there are any tricks and tips you use(experts) when using such connectors while doing component placement.

robertferanec , 06-12-2016, 10:35 AM
I do not have any special tricks for this. Maybe have a look at the iMX6 Rex Development board - that could help you, download the full Altium project here >
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?