Platform forum

New Component PCB Connection Lost

mehmetkazakli , 04-28-2016, 06:46 AM
Hi everybody,
I am desiging a basic led armature using AL5802 I could not find the libraries and created by myself the LED's and AL5802 in my own library.. I matched all the pins during library creating added 3D boyd and so on... I designed my Schematic as you see in figure 1. And uploaded it to PCB document as you see in Figure 2. And the i recognized that some connections (actually lots) are lost (Figure 3). Is there anybody out there that can help me or make a comment on this topic ? How can i connect them manually without getting any error during design rule check. Because when i connect them using "Interactively Route Connector" (figure 4) i got "Short Circuit Errors" during Design Rule Check.
robertferanec , 04-29-2016, 12:22 AM
Please, confirm that pin orientation is not the problem: http://www.fedevel.com/designhelp/fo...rning-messages
mehmetkazakli , 04-29-2016, 04:13 PM
Thank you robert. It was the problem. i used my pin orientatation at wrong side.
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?