USE DISCOUNT CODEEXPERT30TO SAVE $30 USD
Complie successfully in Schmatic project, but not 'fully' in PCB Project.
yu-hao.cheng@terex.com , 04-22-2016, 11:15 AM
Hello Everyone,
I am studying the Switching Power Supply Design Course of part 3. Both the schematic and the PCB are able to compile. However, the PCB project always has this warning message of having "multiple names" for my ground GND and power +VIN. it is extremely normal to see pins referencing to the same power/ground so I wonder if I can do something to tackle this. Will this even cause a problem later on?
Thanks
I am studying the Switching Power Supply Design Course of part 3. Both the schematic and the PCB are able to compile. However, the PCB project always has this warning message of having "multiple names" for my ground GND and power +VIN. it is extremely normal to see pins referencing to the same power/ground so I wonder if I can do something to tackle this. Will this even cause a problem later on?
Thanks
mairomaster , 04-23-2016, 12:35 PM
In the top left of the screenshot you have a power net connected directly to ground. You mis-connected the decoupling capacitor there. That's why you have the warning I guess.
robertferanec , 04-24-2016, 01:22 AM
Hello @yu-hao.cheng@terex.com. @mairomaster is right. There is a short circuit in the schematic:
yu-hao.cheng@terex.com , 04-26-2016, 12:29 PM
Thank you for your help @robertferanec and @mairomaster
Use our interactive Discord forum to reply or ask new questions.