USE DISCOUNT CODEEXPERT30TO SAVE $30 USD
Warning after compilate schematic
Ivan_Mendez , 04-19-2021, 01:00 PM
When I finished I followed indications of this course (Altium essentials) and made Project --> Compile (in my case shows validate PCB project) and as a result shows a lot of warnings because of footprint of X component cannot be found (send you a screen capture attached). It is ok? I would like to know to continue without problems.
Ivan_Mendez , 04-20-2021, 12:50 PM
The Screen photo shows what´s happend when I compile the schematic
robertferanec , 04-20-2021, 10:01 PM
I am working on a video which explains how to fix this. Should be out tomorrow.
Siva , 04-21-2021, 03:19 AM
I faced the same issue but I ignored it since we din't create the footprint at that stage. I believe it is ok to proceed or does it have any issue later ?
robertferanec , 04-23-2021, 03:33 AM
Here is the link to my recent video. Let me know if this helped: https://www.youtube.com/watch?v=f7GP6NZs0Ok&t=922s
Comments:
Ivan_Mendez, 04-24-2021, 05:00 AM
I followed the indications in the video and I don´t Know why but it doesn´t work in my case. When I validate the project continue displaying warnings about "footprint of X component cannot be found"
Ivan_Mendez , 04-24-2021, 05:12 AM
I show Screen captures of the steps followed after watch the video. Robert, Any Idea? Thanks
robertferanec , 04-24-2021, 05:42 AM
Do you have footprints correctly linked to your symbols? It should work if everything is set correctly.
Comments:
Ivan_Mendez, 04-24-2021, 07:35 AM
I start with Altium essentials course and lesson 1 and 2. At the finished on the lesson 2, I did the indication to validate project. I don´t remember have linked footprints to my simbols in fact I currently doing lesson 3 when we are creating the footprints. Could be the problem?
robertferanec , 04-24-2021, 11:01 AM
I don´t remember have linked footprints to my simbols in fact I currently doing lesson 3 when we are creating the footprints. Could be the problem?
Ivan_Mendez , 04-24-2021, 12:57 PM
Perfect. I have just Finished lesson three and The problem was fixed when I complete de footprints in this lesson. But I had a new little problem that I don´t Know to fix. When I was taking measures on the last footprint (capacitor C1210) I went to go back and clean the measures and I didn´t press Shif+C. I don´t Know what wrong keys combination I pressed and I can´t see de footprint screen as the beginning (I Can´t see pads staying on top overlay layer and I could before press the wrong keys combination). Here I show a Sreen capture what I can see now. How can I fix this? Thanks
Comments:
Ivan_Mendez, 04-24-2021, 05:07 PM
I Managed to Fix It. Pressed Ctrl+D (view configuration) and then I selected "Altium transparent 2D" into Configuration.
robertferanec , 04-26-2021, 01:55 AM
PS: This looks to me, like you pressed SHIFT+S ... try to press SHIFT+S multiple time. It cycles between different views.
Use our interactive Discord forum to reply or ask new questions.