USE DISCOUNT CODEEXPERT30TO SAVE $30 USD
PCB Layout Power pins connections
SpikeHawk , 04-03-2021, 08:54 AM
Hi everyone,
I have a question regarding the Power pins connections on layout. As you can see in the attached image I am using a poor to increase the section of the copper around each power pin. Now since I am using this I guess I can delete the previous made tracks where are connected to the pad reference point. So instead of the implementation on the first image I can go with the one presented on the second one.
Regards,
Andrew.
I have a question regarding the Power pins connections on layout. As you can see in the attached image I am using a poor to increase the section of the copper around each power pin. Now since I am using this I guess I can delete the previous made tracks where are connected to the pad reference point. So instead of the implementation on the first image I can go with the one presented on the second one.
Regards,
Andrew.
robertferanec , 04-06-2021, 08:42 AM
Yes, you can do that, but you do not have to.
PS: Just be sure you do not delete too much, so the tracks are still connected well to the polygons.
PS: Just be sure you do not delete too much, so the tracks are still connected well to the polygons.
Use our interactive Discord forum to reply or ask new questions.