Platform forum

High Speed Routing

rhwalton , 03-01-2021, 09:59 AM
Robert.....just finished Lesson # 4 in "Advanced PCB Course" and granted I had to go through it fairly quickly. I was under the impression from the video that you are saying it's better to do high speed routing on the internal layers vs. TOP / BOTTOM layers, despite using VIA's....would this be a correct assumption?
robertferanec , 03-02-2021, 02:34 AM
It may depend on board and application, but yes, I prefer to route inside of PCB. However I am careful about VIAs e.g. I may use uVIAs or buried VIAs to minimize VIA stub in tracks (if possible).
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?