USE DISCOUNT CODEEXPERT30TO SAVE $30 USD
Not able to annotate components
Abhesheksh , 05-26-2020, 04:33 AM
Hi,
In the middle of the udemy course, I was trying to annotate the schematic but there are some dozen components which are still showing up as C? no matter how many times I try to annotate.
Screenshot is attached for reference. Can anyone please help me sort this out? Thanks!!
In the middle of the udemy course, I was trying to annotate the schematic but there are some dozen components which are still showing up as C? no matter how many times I try to annotate.
Screenshot is attached for reference. Can anyone please help me sort this out? Thanks!!
chitransh92 , 05-27-2020, 05:34 AM
Hello,
I am assuming you are using the correct follow on the attached screen i.e, Update Changes List -> Accept Changes (Create ECO) -> Execute -> Close.
This should set the designator.
If this does not work try below:
1. Reset all the designators in the schematic and Annotate again.
2. Delete these bunch of components for which designators are not getting updates and place them again from library something there might be an issue...
Thanks.
I am assuming you are using the correct follow on the attached screen i.e, Update Changes List -> Accept Changes (Create ECO) -> Execute -> Close.
This should set the designator.
If this does not work try below:
1. Reset all the designators in the schematic and Annotate again.
Go to your schematic -> Tools -> Annotate -> Reset Schematic Designator. (this will reset the designator and then annotate again)
2. Delete these bunch of components for which designators are not getting updates and place them again from library something there might be an issue...
Thanks.
robertferanec , 05-28-2020, 06:44 AM
I absolutely agree with @chitransh92
Use our interactive Discord forum to reply or ask new questions.