Platform forum

Polygon Track (0.00254mm or 0.1mil) which I can't delete!

Kentxu , 02-01-2018, 04:20 PM
Hello to all PCB designers!

I'm getting a Polygon Track on the bottom layer, which I think is an artifact from the board outline, and I can't delete it.
It is 0.00254mm wide, so shows up as a Width Constraint error:

Also, it is causing a gap in the polygon pour on the bottom layer because it is not on a net:

Has anyone experienced this, and any ideas on how to select and delete it?

Thanks, Ken

Using: AD15.0
robertferanec , 02-02-2018, 10:19 AM
If it is an artifact from board outline, you may need to go into outline mode: View -> Board Planning Mode. Maybe then it will be possible to delete it?
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?