nachodizz990 , 08-19-2016, 08:58 PM
Hi, all, I enabled xsignals in my project and there is some strange.
I created a separate project to route the flyby chain, without xsignals.
I know that altium if you enter the exact stackup computes the via on the routing but only the portion of the via you enter and exit so itÂ´s fine to minimize skew.
I started flyby from the top vias to Memory 1 and then to memory 2
From the top vias to the Memory 1 i routed 2 mil tolerance all signals, the same for the second stage.
After enabling xsignals, xsignals says there is 40 mil tolerance from memory 1 to memory 2 ...