USE DISCOUNT CODEEXPERT30TO SAVE $30 USD
About variant and component not fitted
mulfycrowh , 01-17-2021, 04:18 AM
Hi everyone,
I am using AD19.
I created a variant.
The attached screenshot shows a component not fitted for this variant.
The question is: why is there a pin that is not greyed out?
Thank you for any idea.
I am using AD19.
I created a variant.
The attached screenshot shows a component not fitted for this variant.
The question is: why is there a pin that is not greyed out?
Thank you for any idea.
WhoKnewKnows , 01-17-2021, 08:03 AM
Looks like a bug.
The important part is whether the objects set as not fitted, and only the objects set as not fitted, all appear to have the red X in the schematics, and, Are these and only these subtracted from the BOM, and are these and only these indicated as not fitted in the pick & place data.
Altium has a bug tracker and enhancement request portal in case you want to let them know.
The important part is whether the objects set as not fitted, and only the objects set as not fitted, all appear to have the red X in the schematics, and, Are these and only these subtracted from the BOM, and are these and only these indicated as not fitted in the pick & place data.
Altium has a bug tracker and enhancement request portal in case you want to let them know.
mulfycrowh , 01-17-2021, 10:14 AM
Thank you.
robertferanec , 01-18-2021, 05:24 AM
I agree with @WhoKnewKnows. Looks like a bug to me too.
Use our interactive Discord forum to reply or ask new questions.