Platform forum

Adwanced PCB layout course Leeson 4 Length Matching

Eduard , 12-22-2022, 01:47 AM
Hi Fedevel Academy,

I have a quastion concerning APLC L4-02.
During this activity as i understand i should length match DIFF100 and ENET differential pairs within the pair and group. For example in DRAM_BANK0 that 11 nets should have equal signal length. As we can see in this first picture below i should length match this diff pair to reach length equal 17.7mm. But i can't reach that value cause as you can see in the second picture i sould length match iup to 68mm and it's not rigth. M.b. i am douing something wrong or i sould change rules?
And i would like to say that length within the pair is equal to each other.

Can you please explain to me what should i do?

Best regards,
robertferanec , 12-23-2022, 02:32 AM
Honestly, I often do not look at the numbers in the bar as sometimes they may show weird things. Is the length matching done from a correct rule? Is not that somehow confused with "within " differential pair rule? I would try to disable the rules and enable them one by one and try them or I would try to length match it based on the numbers in the first pictre and see what would happen with the bar after everything should be length matched correctly
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?