Platform forum

Details for programming and interfacing esp32c3-chip.

anirban0 , 05-06-2023, 03:18 AM
I am developing a PCB where I want to interface my sensor/transducer circuit to an ESP-32 chip with minimal hardware. But I am confused as to how to interface ESP-32 chip with my sensor circuit. What are the necessary components needed for esp32c3 chip?
Anybody could help me in sharing the knowledge for ESP-32 chip configuration and programming. ​
robertferanec , 05-11-2023, 04:10 AM
If you are not sure what to do, then:

- have a look at the module reference design
- have a look at the schematic of a development kit that is using that ESP32 module from the point above

Buy this development kit, connect your sensor circuit to it and once everything is working, build your new board based on the circuit you created + module circuit + kit circuit. If you are not sure, keep all the components in your new circuit, build the first version, then, unfit the components you think you don't need, test everything and make a second version of your board.
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?