Platform forum


karimoviç , 07-05-2020, 04:40 PM
Hello , how i can fanout the BGA ?
robertferanec , 07-06-2020, 08:20 AM
That is a big topic.

But basically, this is what I normally do:
1) powers + grounds + decoupling capacitors
2) memory interface
3) differential pairs and other high speed signals
4) rest of the signals

How exactly to fanout a BGA, it depends on the technology what you can use (e.g. through hole vias only, uVIAs, vias in pad, how many layers, etc), it depends on BGA pitch, ... a lot of factors. It is not som simple to answer.

But, the best is to have a look at reference design and see how they did it.
Paul van Avesaath , 07-09-2020, 03:35 PM
ref designs are the way to go !! but dont be scared to go up a notch in layer count.. in price it doesn't make that much difference, but in time spent it can be a Big difference. also more room makes for a better looking PCB.. if you need a very low cost high volume product then take the time and do it on as minimal amount of layers..but 99% of the time that is not the case..
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?