Platform forum

change solder mask expansion

aycans , 06-30-2022, 01:24 AM
When I add a pad while creating a footprint, the solder mask expansion of the pad is 0.102mm(4 mil) by default. I think, this is a Altium's rule. I want to change rule, but ı don't find where to change. If you have any knowledge on this subject, could you give me information?
robertferanec , 07-08-2022, 12:57 AM
Design -> Rules -> Design Rules -> Mask -> Solder Mask Expansion
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?