Platform forum

copper pour to board outline

Nigel Bishop , 05-28-2020, 06:10 AM
Hi can anyone help, I have just copied the board outline to a polygon pour, assigned a net and re-poured, the copper is going right up to the board edge, how do you pull it back please
df8 , 05-28-2020, 08:18 AM
Put Keep-Out Layer on top of the Board Outline. Adjust line thickness depending on desired clearance.
Nigel Bishop , 05-28-2020, 12:53 PM
Hi I have found a much better way, create a new rule in design rules>board Outline Clearance, Type a figure in minimum clearance, and the copper will pull back from board edge by this amount

Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?