LEAVE A MESSAGE
COURSES
INSTRUCTORS
OUR INSTRUCTORS
BECOME AN INSTRUCTOR
RESOURCES
KNOWLEDGE BASE
FORUM
DISCORD COMMUNITY
USER PORTAL
ABOUT
CONTACT US
SEARCH
$ USD
$ USD
€ EUR
LOGIN
0
GET STARTED
×
Courses:
Top Blog posts:
| KNOWLEDGE BASE
A rich source of expert knowledge
Learn from experts in the world of embedded systems
May 9, 2017
Robert Feranec
9405+ video views
SHOW ALL POSTS
TIP #094: Don't use 4 wire cross junctions
Why? In some cases it is not clear if the signals are connected or if wires are just crossing. Also, it can cause problems when manipulating with wires (e.g. moving or copying them).
May 9, 2017
Robert Feranec
9405+ video views
SHOW ALL POSTS
Prev
TIP #095: You may want to place all the components on the board before you start doing layout
May 10, 2017
TIP #093: Put a big title on the top of each page and put a small title for each chip / block / connector
May 8, 2017
Next
Newest Posts
July 18, 2024
PCB Layout of Differential Pairs vs. Crosstalk - Is track polarity important?
July 3, 2024
How to Make Custom ESP32 Board in Altium Designer | Full Tutorial
June 19, 2024
Simple Trick to Improve EMC - Easy Filter Design for Power Supply
Categories
Hardware design
Tip